I have a rear sight that is supposed to be for a M1 carbine. It has the windage knob in the middle and where it would be installed on the reciever is the same as the reciver. I would include apictures but can't figure out how to incert them. I can email them to anyone that can help. Thanks the windage knob is on centered on the right side and the base requires a male dovetail to install it
Here is a site that will let you down load the Army manual for the M1 carbine repair and maintenance manual with pictures of the rear sight and receiver dove tail.
I have a rear sight that is supposed to be for a M1 carbine. It has the windage knob in the middle and where it would be installed on the reciever is the same as the reciver. I would include apictures but can't figure out how to incert them. I can email them to anyone that can help. Thanks
I don't think you have an M1 Carbine sight. All windage adjustment knobs have been on the right, not middle, and the 'same as the receiver' part is confusing. It's supposed to be the same, or it wouldn't fit into the receiver.
So, get back to us with the photos! Thanks, Joe EDIT-Info Added I noticed it hasn't been mentioned earlier..there are instructions for posting photos on the top of this forum. Good Luck! Joe
If Obama is the answer, it is a very stupid question!
quote: Political Correctness is a doctorine fostered by a delusional, illogical minority, and rabidly promoted by a mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end.
M1 carbine rear sight
Posted - 11/04/2009 : 11:19:35 PM
