Which is it?

n/a

My husband was meticulous about labeling, but I've run into a problem. This box of bullets has one identification on one side of the box, but something different on the other side? Any ideas?

One side says .30 cal 147 gr, but the other side says .302 147 gr.
TIA,
20150514_171005 by Scotchheather, on Flickr

20150514_171018 by Scotchheather, on Flickr

20150514_171036 by Scotchheather, on Flickr

NeoBlackdog

More than likely there's a micrometer laying around the reloading bench somewhere. Measure the diameter of one of the bullets. Odds are they'll mic out to .302". Most common '30 cal' bullets will be .308, so I'm not sure what these'll fit. One of the really smart fellas should be along any minute to fill us in on that.

Edit,
.302 is equivalent to 7.67mm, if that helps anything.

charliemeyer007

.302 is like a 7.35 x 51 Carcano. Use the scales to check the weight and the dial caliper to check the diameter.

added A long time back I bought a big sack of pulled 30 Cal FMJ that were not boattails but were very cheap. I don't remember the weight but they were.302 and the guy selling them said they were from the Carcano.

7.35 Carcano .298

7.5 Swiss .306

7.5 French .310

7.65 Argentine .313

http://en.wikipedia.org/wiki/7_mm_caliber

Hawk Carse

A micrometer would tell the tale. Ask around among your husband's friends, most handloaders have one.
I don't know what a .302" bullet would be good for. 7.35 Italian is right at .300".

waltermoe

They look like 147 grain FMJ (full metal jacket) bullets to me, I load quite a few of them and that's what they look like. The 302 I don't know what that would relate too, as 30 caliber bullets should be .308, the S following the 147 could be his own code for solid, some people call FMJ bullets solids or ball ammo.

Tailgunner1954

Your husband sorted by diameter, as well as weight. Probably got a bunch of surplus and culled out the worst offenders
Those are at the low end of tolerance for a 30cal bullet (.308 is the NOMINAL size, with a +/- tolerance).

n/a

Thanks ya'll.

62fuelie

Could also be for the 7.5 Swiss or the 7.5 French or 7.35 Argentine

p3skyking

Since the .30 marking is original and the .302 was added, I would think .302 is correct. I would do it the same way, but oblitherate the original marking just for such occasions as this.

buschmaster

.302 is ".30 cal". since a .302 isn't ringing a bell with any of the braniacs you need to get a mic and check them all over again if you want to avoid disappointment.

tsr1965

I might think that if your husband was this stringent, and that's a good thing, that these might be some custom sized bullets, as the 0.302's are hard to find.

I truly think these started life as the standard 7.62mm/0.308" diameter 147 grain FMJ type bullets, and were bumped down for use in a rifle with a smaller bore.

And to be PEFRECTLY CLEAR, 0.300" IS 30 caliber, not 0.302", or 0.308". More so, 30 caliber is a bore diameter, not a bullet/projectile diameter.

Best