Marlin Model 60

bwheelersc

I was in in a shop yesterday looking at two Marlin model 60's. One was a newer model and had a shorter mag tube under the barrel. Has Marlin gone politically correct and limited the new model 60's to ten rounds?

Chris8161
Admit nothing, deny everything, demand proof!

bwheelersc

My nephew recent was given a new marlin model 60 semi-auto .22 rifle. He is only 5 years old so the stock is too long for him. I have looked online for a shorter stock for the marlin and can't seem to find anything. Is there a smaller stock made for the marlin or do i just need to buy and replacement and modify it until he gets a little bigger and if so where is the cheapest stock i can find. Thanks

bwheelersc

My .22 is acting up on me. I can't get more than a few shots fired before it jams. Typically, the spent shell isn't ejected properly and it interferes with the new round. I'm using Remington ammo, and I've cleaned & oiled the weapon.
Anybody got any ideas?
GH1[:)]

bwheelersc

When looking for parts for a Marlin model 60 I notice they have new style and old style. How can I tell if I have a old style or new style? Thanks for any help. Terrill.

bwheelersc

I have a marlin model 60 and the firing pin is just barely hitting the rim of the shell, most of the time not well enough to ignite, any ideas or suggestions would be a big help.
Thanks,
Chuck.

bwheelersc

I have a glenfield model 60. Had it for about 25 years.

After resting it for the last 10 years I took it out to give to my son for a B-day present.

It would fire but repeatedly jammed so I had a friend look at it. All the parts looked really good, very little wear for a 25 year old gun except the tabs were the lifter contacted the feedthroat. They broke with very little contact when I sdtarted to inspect it in detail.

I called marlin and gave em the serial number and was sent the new model feedthroat. I wasnt told that I needed the conversion kit but after trying to modify the feedthroat realized it wouldnt work so I got the conversion kit and breech bolt ( from brownells, marlin and numrich didnt seem to care much and were NOT helpful )

My problem is that the older model has two mounting posts on one side and one on the other. The new model has two on each side.

When I purchased the initial feedthroat. It appeared to be very close and so we grinded down the one post but the action would freeze up ( when attempting to simply pull the bolt manually ) so I assumed that it was the wrong feedthroat.

Hence the second purchase of the whole Kit. The new kit came with the feedthroat. The ejector bar and spring and the breech bolt.

The new feedthroat is exactly like the first one I purchased. Two mounting posts on each side.

So do I grind this one down also and try and get it to work or Do I purchase the new plates also ??

I have spent enough already to almost buy a new ruger 1022 or a really good used model 60 and am trying to decide if I should send the parts back and do just that but hate to throw away an old friend that I had planned to give to my son.

ripley16

Even with a shortened stock the model 60 is a bit much for a 5 yr. old. Buy him a Cricket, keep the Marlin for later.

hedgehopper62

The model 75 was a shorter model of the 60 marlin.tks.hedge[:D]

RCrosby

Depending on the size of your nephew you may want to consider the Cricket idea. Otherwise you could always shorten the stock about an inch; re-install the original buttplate, then down the road replace it with an extra thick recoil pad. You'd regain the lost length and even on .22's recoil pads are great for non-slip, lean it in the corner of the gun cabinet type storage.

beantownshootah

To be clear, you don't NEED to have a replacement stock. You can just cut down the current stock, and then if/when he gets big enough to need a bigger stock, THEN get a replacement one.

FWIW, you can sometimes find replacement stocks for around $50 on Flea-bay and elsewhere.

The problem is, used Marlin 60 rifles are only worth around $100 or so, so how much does it make sense to swap out a stock for $50?

But apart from all of that, my suggestion is just to hold this gun for him until he's older.

Bluntly, an adult sized tube-fed semi-automatic rifle is probably too much for a five year old.

Without questioning the wisdom of such a gift to a small child, he'll probably do much better with it when he's 10-12 years old.

If you MUST have a gun for a small child, I second the vote for the "Cricket" which is a small single shot rifle designed for children. The single shot promotes both marksmanship and safety.

joshmb1982

ive never shot the cricket idea. i learned on a marlin single shot 22 bolt action. i couldnt hazzard a guess on how many hundreds(mabye thousands) of rds i out down range with that rifle at ages 5-8. should definatly be a small single shot of some type.

lts

IMO, I found the little ones didn't like the the chipmunks and crickets, reason being very frustrating to load and cock. The little uncoordinated fingers fumbling a little 22 round into the chamber takes the fun away. So does not being able to cock the rifle. Brought out the old single shot winchester 121 that can feed load and got the smiles back. Keep the autoloaders away until they're proficient with a single shot this way if they make a mistake you'll only get shot once. I had also cut down a 10/22 stock, needlessly too, the kids grow very quickly..

bwheelersc

Thanks for the opinions. I'm guessing that it will not be long until he goes into it. He is extremely big for his age. I just thought if i could get a used cheap stock for 20 or 30 bucks I'd buy it.

WCI

IF you hurry and still available I saw a AR type stock six position in Cheaper than dirt awhile ago. This might work.