In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.
Options

Hi Power Mag Disconnect Removal

penguinpenguin Member Posts: 596 ✭
edited October 2016 in Ask the Experts
Would this be a safe practice and would it improve trigger functions?
· Share on FacebookShare on Twitter

Comments

  • Options
    11b6r11b6r Member Posts: 16,588 ✭✭✭
    edited November -1
    yes and yes
    · Share on FacebookShare on Twitter
  • Options
    charliemeyer007charliemeyer007 Member Posts: 6,579 ✭✭✭
    edited November -1
    I'm not sure it helps in trigger pull a lot, but I'll take a single shot over a no shot any day. I would have loved to ask Mr. Browning about this improvement in design, but thankfully it is easily "corrected".
    · Share on FacebookShare on Twitter
  • Options
    M1A762M1A762 Member Posts: 3,426 ✭
    edited November -1
    If you are hesitant to remove the magazine diso, I would suggest keeping it but give the face of the diso a good polish, as the area on the magazines that it rubs against.

    This will improve the trigger, it will be less gritty. I always remove the mag disco, as stated above a single shot is better than a no bang.

    Change the hammer spring to a 23lb. spring. Polish the sear or get one from Cylinder & Slide. You will have a superb trigger then. [:)]
    · Share on FacebookShare on Twitter
Sign In or Register to comment.