.

WTB .183 (4.6mm) diameter soft point bullets

220sw220sw Member Posts: 27
Looking for supplier of .183 Dia bullets to reload 4.6x30
Anyone have any information ?

Comments

  • XXCrossXXCross Member Posts: 1,316 ✭✭✭
    edited November -1
    You might try looking for custom bullet makers. There used to be several people using Corbin swagging dies to make all sorts of sizes.
  • pip5255pip5255 Member Posts: 1,559 ✭✭✭
    edited November -1
    midway did have them
    just because you could doesn't mean you should
  • 220sw220sw Member Posts: 27
    edited November -1
    Thanks for the suggestions, I have searched about on the net to no avail, midsouth shooters had a large lot of blems as well as midway, was some time ago. I have a little 1771 anschutz bolt action in this caliber, have to be content to shoot factory ammo for the time being. In the late 70s early 80s was the same with the 17s ...but there were a few custom shops making them obscure ads in gun magazines back then, however I believe the 4.6mm caliber is pretty much a "one off" ....nothing too special or wonderous!!!!
Sign In or Register to comment.