Reloading tip.

EhlerDave

Tip #1. After you load your powder DO NOT turn the case over to check the primer. [:D]

guntech59

....or put the powder in before the primer.....not that I have done that....[:I]

BGHillbilly

Starting bullets with the pointy end going into the case is easier but does not turn out well.

bambambam

Don't feel bad.

I loaded a .357 one time, looked at the primer & it was in upside down(anvil facing out).[:I]

peddler

Done all 3

EhlerDave

You folks are making me feel better, Thanks. [:)]

bambambam

I just got a bullet beater (kinetic puller) because i was tired of looking at the "island of misfit toys" aka the ones I screwed up.[:D][:I]

shoff14

Don't forget to change out your flare die with your seater. With lead bullets, it seats fairly easily, just a tad deep....

wanted man

Turn away from that tray of powder on the scale BEFORE you sneeze [;)]

Riomouse911

If you accidentally drop a tray of primers on a rug, use your fingers to comb through and pick them up. Vacuums case lots of "bangs". [:0]

CapnMidnight

Put an old low edged cookie tray under your shot shell loader.
Makes the shot easier to pick up.[:I]
W.D.

sandwarrior

Forget to label the powder in your powder dispenser, then double down and dump what you thought was H1000 into a half pound (remaining) of H1000. Only to find out when you were about to dump the trickler, that what you dumped in the H1000 was really H4895[B)][B)]

Remember to put powders away or have a handy labeling system.[;)]

charliemeyer007

Just because you have shot 5 kegs of Blue Dot under the Hercules label doesn't mean Alliant Blue Dot Loads or shoots the same.