In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.
Stock ID please
jpc
Member Posts: 330 ✭✭✭
Came in a group and can't ID it.............
Hardwood
thanks for the help
Hardwood
thanks for the help
Comments
Then take the pic again.
:?
Note the rear of inletting is chipped out from recoil against too tight contact.
That "chip" looks like one, but it's from the cocking piece on the Mauser bolt. Either inletted like that, or the CP will cut it's own groove.
hillbille, the Mauser safety sits on top of the bolt shroud, well above that notch. Even a left hand low scope safety with a 3" lever would still clear the stock. I've racked my brain trying to figure out wth that cutout would be for. It sits too far back for a receiver sight.
My best WAG would be a left hand side safety trigger, but...there would be inletting apparent on the inside of the wood for clearance.
trap could that notch be so the safety will flip all the way down and catch, instead of stopping short and resting on the stock??? looks like a small line right in the center in the last picture.