herter's die sizing question
joes Member Posts: 484 ✭✭✭
edited May 2012 in Perry Shooter Competition Shooting and Reloading Forum
I purchased a set of herter's dies in 44 mag and am having an issue. After sizing 50 rounds of brass I loaded one round to find the bullet was loose in the case. I then tried to put bullets in sized brass and found some cases were a tight fit and others the bullet would just fall into the case ( the die setting was not changed) . Is there something I am missing? I tried to crimp the case mouth by screwing the die further down and again no change. Any suggestions?