In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.
Options
Breda Accessory ????
jpc
Member Posts: 330 ✭✭✭
Hello
Not sure what I have here.
The wrench is aluminum with a steel insert. The insert is tapered about two-thirds of the way with fine grooves not threads.
thanks for the help
jpc
Not sure what I have here.
The wrench is aluminum with a steel insert. The insert is tapered about two-thirds of the way with fine grooves not threads.
thanks for the help
jpc
Comments
Breda used choke tubes with internal threads that screwed on over the muzzle instead of into it. The tool for cutting those threads looks just like that. There's a piece that fits into that, that has a pilot shaft to fit the bore, and is surrounded by "fingers" that cut the barrels external threads.
take care
jpc
Sent: Friday, May 31, 2019 3:21 AM
To: JPC
Subject: Re: Information Please
Good morning,
this is a very old tool used to ?re-balance? the profile of 12gauge shells.
Hunters were used to reload by themselves ammo and, after the process, the profile of the shell may be not straight. This tool needs to make it straight again after the reloading process.
PLease consider that many shotshells in Europe were made in carton-paper too? this is why this tool was important.
Best Regards
MicheleM | Customer Service
Info@bredafucili.com