In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.
Aiming point / scope
diver1
Member Posts: 502 ✭✭
I having a crisis of faith ( skill ). When your scope is set for 100 yards. If your target is say 50 to 75yds do you change your aiming point? If it's over 100yds I would hold a little high, dose the converse of that hold true closer aim lower ? I am shooting a Remington 280 which I think shoots flatter than say a 270. Thanks
Comments
For your 280 I would site in about 2 in high at 100 yards and in that time the bullet will be all over the crosshairs up to 100 yards.
2 in high at 100 yards would keep you good for vital shot 10-150 yards
https://www.youtube.com/watch?v=VqOqZBRZsj8
Ros
Go range and shoot one shot at 50, 75, 100, 125 and 150 yards then you'll know where your bullets hit at those ranges.
Yup, I concur. I usually set all my scopes at 100 yards. Anything less then that distance, I still use the center as my point. You have a large enough kill zone on deer and hogs, to not to have to worry about it much. Hope that helps.
I having a crisis of faith ( skill ). When your scope is set for 100 yards. If your target is say 50 to 75yds do you change your aiming point? If it's over 100yds I would hold a little high, dose the converse of that hold true closer aim lower ? I am shooting a Remington 280 which I think shoots flatter than say a 270. Thanks
At 50-75 yards the bullet will be SLIGHTLY lower, lets say 1/8" inch. This is because the bullet is launched on a BALLISTIC flight while your sight is a straight line.
If you sight your rifle in at 100 yards the bullets flight and your line of sight meet. The bullet "climbs" from the muzzle the distance between your bore and the horizontal cross hair to be "on target" at the 100 yard distance you sighted in for.
For all practical purposes you do not adjust aim points on game until the range gets extreme for the cartridge being used. A deer will never know the difference at 50 to 250 yards with your caliber. If you do your part, don't jerk the trigger, and have a solid cheek weld and good sight picture the 2-1/2 inch difference from 50 to 250 yards still spells a dead deer.