In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.
pulley measurements
Robin
Member Posts: 1,228 ✭✭✭✭✭
Hello folks,
I am restoring an old Craftsman jointer. I picked up a 1/2 hp electric motor. A reprint of the old manual calls for a 5" pulley for a 1/2" V belt. How are these pulleys measured? Is it the diameter, circumference or something else
Edit: Thanks for the information, so a 5" pulley would have a 4 1/2" OD diameter if the belt is 1/2". The guy at the hardware store doesn't know how to measure pulleys.
I am restoring an old Craftsman jointer. I picked up a 1/2 hp electric motor. A reprint of the old manual calls for a 5" pulley for a 1/2" V belt. How are these pulleys measured? Is it the diameter, circumference or something else
Edit: Thanks for the information, so a 5" pulley would have a 4 1/2" OD diameter if the belt is 1/2". The guy at the hardware store doesn't know how to measure pulleys.
Comments
The velbet is measured at the widest width, not the thickness. Most 1/2" belts are 1/2" wide at the widest point, and about 5/16" at the thinest point and about 5/16 wall thichness.
http://www.gizmology.net/pulleysbelts.htm
Margaret Thatcher
"There are three kinds of lies: lies, damned lies and statistics."
Mark Twain