1996 Suburban, 7400 Vortec

easygo6

I just purchased this vehicle. Gave it a front end grease job today. I expected a few 'zirc' (sp?) fitting for replaced parts...but every 'typical' joint had a zirk fitting. Are all the zirc fittings replacement parts?...where all original fittings 'sealed'? This includes the upper and lower balls, the tie rod ends, and the steering 'thing a mah jig'.

It is a K2500... 4WD 3/4 ton

Cutiegirlracing

Stock, I thinks it's all sealed bearings. I also think that most of it, if you need to replace it will be in assemblies You can't buy just the parts.

shoff14

My fathers 2500 P/U is all sealed.