UNIVERSITY50

tazzer

Hey I checked under the truck and found the slave cyc. but the lever on the trans. feels locked up also I cant get it to move. [B)]

UNIVERSITY50

That lever should be connected to the Throw out bearing. It would be very hard to push / pull by hand. Since it is hyd. clutch and goes to the floor without pressure the system is low or dry, Mice may have chewed the plastic line. Also the clutch master cylinder may be bad from sitting. Put brake fluid in it and see if it will pump up or if you can see a leak. The master cyl. will usually leak into the cab at the firewall. Pushing the throw out bearing to release the clutch by hand would be very hard to do, but the throw out bearing fork may also be siezed up in the bellhousing. All are easier repairs then pulling the trans![:)]

tazzer

quote:Originally posted by UNIVERSITY50
That lever should be connected to the Throw out bearing. It would be very hard to push / pull by hand. Since it is hyd. clutch and goes to the floor without pressure the system is low or dry, Mice may have chewed the plastic line. Also the clutch master cylinder may be bad from sitting. Put brake fluid in it and see if it will pump up or if you can see a leak. The master cyl. will usually leak into the cab at the firewall. Pushing the throw out bearing to release the clutch by hand would be very hard to do, but the throw out bearing fork may also be siezed up in the bellhousing. All are easier repairs then pulling the trans![:)]

thanks, I ordered both of them today and should be here by thur. so hope to have it going by thur afternoon [:p][:D]