In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.

Anyone have a Mectech Glock Carbine Conversion?

CS8161CS8161 Member Posts: 13,596 ✭✭✭
edited October 2012 in General Discussion
I have been wanting a 10mm carbine and was looking at the Mechtech uppers that use a G20 frame. Has anyone put a 10mm carbine together this way? Any issues or problems?
· Share on FacebookShare on Twitter

Comments

  • AnonymouseAnonymouse Member Posts: 4,050
    edited November -1
    I have one, no problems at all.
    · Share on FacebookShare on Twitter
  • tsavo303tsavo303 Member Posts: 8,914 ✭✭✭
    edited November -1
    tell us some more, i am curious also
    accuracy, reliabilty, slickness?
    · Share on FacebookShare on Twitter
  • poshposh Member Posts: 360 ✭✭
    edited November -1
    What is the story on the plastic piece Mechtech says is necessary to make the carbine feed properly?
    · Share on FacebookShare on Twitter
  • AnonymouseAnonymouse Member Posts: 4,050
    edited November -1
    The glock block is a feed ramp. You just put it in place, and slide the CCU on, and the block stays in place. As for accuracy, etc: I get around 5" at 50 yards, standing, with a 1X red dot on it, using Silvertips. I have never shot it off the bench, so don't know what it is capable of that way. I don't really keep close track of round count, but it has quite a few and has been 100% absolutely reliable. Recoil is about nil, as the unit is pretty hefty.
    · Share on FacebookShare on Twitter
Sign In or Register to comment.