Baretta 92F Barrel

WCI

I have looked in Brownells but could not find a replacement barrel. Can anyone make any suggestions on one. Someone was looking at it awhile back who shoots alot of Glocks and commented that ( I suppose ) the slide felt sloppy? What can i do to correct it. Most of my experiances are with my bolt action 700's and revolvers. I have had accuracy problems with the 92, It will not hold a group even off a bench. I bought this one used, 200.00 but I had heard the guns owner, I bought from there father, The son had some high capacity magazines and shot a lot. I am thinking it might need to be overhauled. Also the blueing is really warn in some places, partly because this is one I carry, I have seen paints and bake on's, and blueing compounds thru brownells could you suggest the best route for ease of application and longevity.
Thanks

Wehrmacht_45

A 92 FS barrel will fit in your 92F. Barsto makes some top notch barrels for your gun. You could also most likely buy one from Beretta USA. I would also replace the locking block and recoil spring while you are at it. That should help accuracy by tightening the barrel to slide fit.

http://www.midwayusa.com/eproductpage.exe/showproduct?saleitemid=710133&t=11082005


As for the cosmetic issue you have. I would suggest you look into Aluma Hyde II from Brownells.


However by the time you do all this you will have 400 dollars in a gun that is about 500 new. If you slide to frame fit is sloppy, you might be better to look for a newer used 92FS.

dcs shooters

You might replace the locking block first, as they wear out fast if not kept clean and lubed.

WCI

I actually just e-mailed Midway about one. I could not find one on there web site. Thanks for the info and any help finding one if you have any ideas

dcs shooters

www.midwayusa.com Part number 710133 Bar-Sto barrel