In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.

H&H 91/93 CLONE

riveratriverat Member Posts: 2 ✭✭
edited December 2008 in Ask the Experts
WHAT WOULD CAUSE THE BOLT NOT TO CLOSE FULLY ON MY CETME .308 91/93? I CAN TAP THE BARREL SLIGHTLY ON THE FLOOR AND IT CLOSES.
· Share on FacebookShare on Twitter

Comments

  • rufe-snowrufe-snow Member Posts: 18,650 ✭✭✭
    edited November -1
    Don't know who made yours? Some were made up with receivers made out Aluminum castings. These particular versions have caused folks a lot of grief. Try placing a magnet on your receiver to see if you have been stuck with one of these loosers.
    · Share on FacebookShare on Twitter
  • Wehrmacht_45Wehrmacht_45 Member Posts: 3,377
    edited November -1
    Is it a CETME or a HK91 Clone? Not the same gun.

    If it is a Century job it might be built on a Hesse reciever, and that is rarely a good thing.
    · Share on FacebookShare on Twitter
  • GrasshopperGrasshopper Member Posts: 17,018 ✭✭✭✭
    edited November -1
    Might not be anything wrong with it/ Let the bolt "go" to load it. IF it still doesn't close, then take it to a real smith. I have and do own some "alloy" receivers HK versions and have had no problem. Others, by hearsay or bad experience must have had a problem or two.
    Lots of people jump on the "bandwagon" about bad this and that, I have/ had many firearms and have/ had a few problems with all brands of guns. Just like a vehicle, some swear at Ford some swear by it..imo..nambu
    · Share on FacebookShare on Twitter
  • NwcidNwcid Member Posts: 10,674 ✭
    edited November -1
    As it was stated before a CETME and HK 91 are not the same thing. A HK 93 is not even the same size or caliber.
    · Share on FacebookShare on Twitter
Sign In or Register to comment.