In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.

HSc reassembly problem

poshposh Member Posts: 360 ✭✭
edited August 2018 in Ask the Experts
Newly purchased (On GunBroker ) an Interarmco HSc that had fail to feed issues. Took it apart to inspect and clean but can't get the slide back on. The part identified as the "Magazine safety" hits the back of the slide stopping the installation of the slide. I've tried various solutions including inserting the magazine and pulling the trigger. Nothing worked. Any help would be appreciated.
· Share on FacebookShare on Twitter

Comments

  • rufe-snowrufe-snow Member Posts: 18,650 ✭✭✭
    edited November -1
    It been awhile since I owned a HSc. Also it was from W W II. Not one of the post war pistols.

    With the pistol disassembled. Try depressing the takedown latch in the trigger guard. See if that moves the mag safety that is attached to the right side of the frame.

    Also the manual safety on the slide, has to be in the safe mode. During reassembly. With hammer cocked.

    The slide in reassembly, has to be pushed down and than back. To properly engage with the frame.
    · Share on FacebookShare on Twitter
Sign In or Register to comment.