need info about reloading and equipments....

smooth_operator

I planning to start reloading sometime within the next few months and was wondering which unit I should spring for... also, I wouldnt mind buying used if one is available. Any info would be greatly appreciated.thanks,smooth

smooth_operator

Saxon, Actually, I am leaning towards a single stage press anyway...since I'm new to this, I'm in no hurry to load. After years of shooting with Federal match ammo, I got tired of paying the 1$ a shot they charge for em.-smooth

---

Life is the leading cause of death.Everything else is just a contributing factor.

spclark

The RCBS RockChucker kit comes with just about everything you need to start reloading for pistol and rifle, except powder, primers, dies, a caliper (but a digital; you'll be happier in the long run) and some way to clean up your used cases. You can usually find the kit on G'B for a bit over $200 & at some gunshops as well. A good set of pistol or rifle dies will run from $25 to $50.Study the manual that the kit provides (or first buy a reloading manual printed by one of the major brand bullet manufacturers) for the set-up and safety concerns of the equipment & procedures involved.Unless you have someone who can "show you the ropes," take it slow at first & be sure you're following what the manuals are telling you. There's a reason for everything they suggest. *PLEASE* follow the rules and loading tables for the cartridge(s) you want to shoot.I guarantee you'll not only save money once you become proficient with your new equipment, but also shoot more accurate ammunition (& more of it too, which makes for more fun & a better marksman) because you can tailor your loading - within limits - to the needs of both your weapon(s) and purpose.

flinch

I started with a Lee kit and dies and was very happy with the results. Very enexpensive way to get started and the quality was better than the price I paid (F & M reloading). I used Lee's premeasured powder dippers and felt safe and foun it was pretty much a no brainer. No measuring, no scales, no checking if the right amont was thrown into each case. Like you, I was just looking to save more $$'s and shoot more bullets. The dippers saved a LOT of time and were very reassuring when it came time to pop that first cap. Safety first always.

ref44

I have reloaded about 103,000 rounds over the last 21 years using an RCBS Rock Chucker.Everything has been volumetric, using the Little Dandy powder funnel and rotors. I'd guess 90% has been pistol reloading, and I choose those rifle powders that will meter smoothly.I know two guys who started with progressive presses that blew up guns. A problem developed at one position, and they did not recognize they were dropping double charges of powder as they corrected the problem. The press was not totally at fault; but their lack of experience coupled with the relative complexity of the operation led to a bad situation.In one case, I had fired the fellow's SA revolver three time before handing it back to him. He fired the next round, and it took out the side of the cylinder along with the topstrap of the gun. One fragment went through both sides of a hard plastic box sititng on the adjacent bench. I had just moved away from the path that fragment took.As noted earlier, unless you are really into volume production, I'd suggest starting with a single-stage press.

Giuseppe James

I also started on a RockChucker - recently bought a DIllon and see no reason you could not start with a progressive. I would suggest taking a look at the "Square Deal B"