In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.

Security Six

garandfangarandfan Member Posts: 271 ✭✭✭
edited June 2002 in Ask the Experts
i have a security six that is stainless and has th red box and no warning on the barrel what would it be worth 95%. serial 153-09003
thanks
6" stainless
· Share on FacebookShare on Twitter

Comments

  • garandfangarandfan Member Posts: 271 ✭✭✭
    edited November -1
    I have a Ruger Security Six and after shooting 6 rounds, the cylinder becomes very difficult to turn. It feels like it needs a good cleaning because after you turn the cylinder a lot it becomes loose again and will spin fine. Then it becomes difficult to turn again after shooting six more rounds. Does anybody know where I could find information on taking the cylinder out and apart? I have looked on the internet for disassembly guides but I haven't had any luck. Thanks.

    "To be prepared for War is one of the most
    effectual means of preserving peace"-George Washington
    · Share on FacebookShare on Twitter
  • garandfangarandfan Member Posts: 271 ✭✭✭
    edited November -1
    Will any other Ruger sights work on it?
    · Share on FacebookShare on Twitter
  • bullelkbullelk Member Posts: 679 ✭✭✭✭
    edited November -1
    Does that happen after shooting the +P+ cartridges thru it??
    · Share on FacebookShare on Twitter
  • thunderboltthunderbolt Member Posts: 6,041 ✭✭✭
    edited November -1
    Write to Ruger and they will send you a manual.
    · Share on FacebookShare on Twitter
  • garandfangarandfan Member Posts: 271 ✭✭✭
    edited November -1
    bullek,

    I've never shot any +p or +p+ ammo through it.

    "To be prepared for War is one of the most
    effectual means of preserving peace"-George Washington
    · Share on FacebookShare on Twitter
  • bullelkbullelk Member Posts: 679 ✭✭✭✭
    edited November -1
    Try squirting some fine gun oil down the ejector rod shaft, and work it a bit.
    · Share on FacebookShare on Twitter
Sign In or Register to comment.