Marlin 39A cartridge cuttoff spacer ?

Uintah

Does anyone know if a 1976 vintage Marlin 39A Golden would have the seperate cartridge cuttoff spacer? Marlin cannot tell me for tht age and the new ones do not have that part. I suspect from viewing a 1972 parts diagram for the 39A, which shows the cartridge cuttoff spacer as a seperate part, that 1976 would be the same. I have had feeding issues and upon dissassembly discovered only the cartridge cuttoff in place, with no spacer. Numerich is currently out of stock and Marlin considers that vintage obsolete and does not have any parts. If you have any other locations for one, please let me know. Thanks

charliemeyer007

The last 39A I work over years ago for feeding issues had the separate spacer. I tweaked the cutoff to make it work correctly.

http://www.gunpartscorp.com/Manufacturers/MarlinGlenfield-33379/Rifles-37333/39Series-38980/39AEarlyModel-34037.htm

Geri

Try JACK FISRT,INC 1201 turbine drive Rapid Cit, SD 57703 605-343-9544

toad67

http://wisnersinc.com/rifles/marlin/rflever.htm

Emmett Dunham

I have an older model 39 and the cut off has spring tennsion and it springs back every time a bullet passes to catch the next so the receiver does not get flooded with shells. I just took a small screw diver and pulled the stop up and it cured this problem and it has been quite a while since I did that. I would get the right screw driver and take stop out of the receivr (soak it in Kroil first) and clean the area behind the cut off and see if you can get it working by putting tension on the stop again. If that does not work buy a new one.