In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.
Options

Griffin & Howe scope mounts/detachable

jaegermisterjaegermister Member Posts: 692 ✭✭✭✭
edited November 2013 in Ask the Experts
I have detachable , side levers, slide on , with small diameter scope. Would like to add a 1in
Ring scope to my 98 base. Are all g&h mounts same? What do I look for?

Comments

  • Options
    Hawk CarseHawk Carse Member Posts: 4,374 ✭✭✭
    edited November -1
    Best I can tell, you could change out the rings, but if you want a complete top half, bracket and rings, "some adjustment and fitting to existing base will be required."

    G&H still make them, ask them what it takes.
    http://www.griffinhowe.com/mountsandpads.cfm
  • Options
    MPMP Member Posts: 265 ✭✭✭
    edited November -1
    If your base is for the double lever you should have little trouble locating a 1" mount.

    Most of the smaller diameter mounts have windage built into them and hard to find larger rings that will fit.

    A picture of what you have might help.
  • Options
    jaegermisterjaegermister Member Posts: 692 ✭✭✭✭
    edited November -1
    Thanks I have located a top section with rings and presently sending pics to owner.
  • Options
    dfletcherdfletcher Member Posts: 8,164 ✭✭✭
    edited November -1
    Getting 1" rings should be easy and a simple matter of swapping out. Regarding the upper bracket, they are to a certain extent adjustable. I have an NRA Sporter that Grandad (for better or worse) had G & H do work on about 1935 and over the years I've had to tweak the tightening tabs a bit. Always drives me up the wall because it's so infrequent I forget how the heck to do it.

    If your mount is older you may want to find older rings so the appearance matches best.
Sign In or Register to comment.