In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.

Quick question

hr223shooter07hr223shooter07 Member Posts: 33 ✭✭
edited November 2007 in Ask the Experts
Hey everyone, our firearm deer season opens in two days, I have been doing a lot for out trip, have class tomorrow, today I sighted in my muzzleloader, it is a x-150 winchester with 3-9x bushnell banner scope on top, i cleaned it afterwards really good, probably the best ever, well in the cleaning process I left the stock attached, afterwards i was making sure everything was still torqued down good, and the action screws were tight, but i tightened them a little bit more, my question is, after tightening the action screws, PROBABLY not even a 1/2 turn more, will this significantly throw off my poi?...or should i be set and not worry about this?...i really don't have the time to mess around resighting it it, at 50 yards i set it so it hit 2" high so it was pretty good out to 100, is this going to screw me up or no?
· Share on FacebookShare on Twitter

Comments

  • hr223shooter07hr223shooter07 Member Posts: 33 ✭✭
    edited November -1
    can any of you guys determine what type of gun a person should buy or help correct problems with accuracy just by looking at pics of targets?

    problems not so much with the gun itself but with hand position, control, etc.
    · Share on FacebookShare on Twitter
  • hr223shooter07hr223shooter07 Member Posts: 33 ✭✭
    edited November -1
    The Michigan opener for deer is monday, i recently made sure my ultra slug hunter was sighted in, i shot it, then took it apart and cleaned it, would removing the barrel from the frame and the forearm change the point of impact, i didn't mess with the sights, but will it change it significantly? I never noticed a change in where in hits before when I took it apart...should i be fine for the opener?
    · Share on FacebookShare on Twitter
  • hr223shooter07hr223shooter07 Member Posts: 33 ✭✭
    edited November -1
    What year did they make the first 3inch magnum. 20 Ga. shot shell
    Thanks Karl
    · Share on FacebookShare on Twitter
  • hr223shooter07hr223shooter07 Member Posts: 33 ✭✭
    edited November -1
    About how much is 60 inchpounds, I ask because that is how much the HS precision stock should be tightend down from what ive seen. Just wondering, is that just barely hand tight, or real tight...i dont have a guage and want to shoot. Thanks
    · Share on FacebookShare on Twitter
  • bpostbpost Member Posts: 32,669 ✭✭✭✭
    edited November -1
    No; Be safe, be calm, be invisible and successful. Good luck and have no worries. You are not shooting Benchrest, you are shooting deer,WE HOPE!
    · Share on FacebookShare on Twitter
  • hr223shooter07hr223shooter07 Member Posts: 33 ✭✭
    edited November -1
    I figured it wouldn't mess it up too bad, yes, I am hunting deer...lol thank-you, for your advice!
    · Share on FacebookShare on Twitter
Sign In or Register to comment.