In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.

Parts Needed/

TinkerjohnTinkerjohn Member Posts: 5 ✭✭
edited November 2007 in Ask the Experts
I was just given a interarms/ Rossi revolver. The model is 971 357 mag. with a six inch barrel. The cly seems to be bent on the shaft that it turns on? Also the shell ejector rod and spring appears to be gone? My question is, is this just a paper wieght or are there parts available to repair this gun? Thanks John//////////////
· Share on FacebookShare on Twitter

Comments

  • charliemeyer007charliemeyer007 Member Posts: 6,572 ✭✭✭
    edited November -1
    I'd bet there are parts around. Sounds like it was Dick Tracyed once too many times. For what you have in it support your local gunsmith. All the Rossi I have had shot ok and were good value for the money.
    · Share on FacebookShare on Twitter
  • nmyersnmyers Member Posts: 16,892 ✭✭✭✭
    edited November -1
    There is only 1 factory authorized Rossi gunsmith: M&M Gunsmiths, Alexandria, VA.

    Neal
    · Share on FacebookShare on Twitter
  • 1KYDSTR1KYDSTR Member Posts: 2,361 ✭✭✭
    edited November -1
    Hey Neal...they were the guys who repaired my Rossi levergun and did a fantastic job. The extractor was grossly oversized and would not even close on a chambered round without ripping most of that area of the rim clean off. The trigger was pi** poor, but when I sent it back I didn't even mention that. The gun came back as slick as goose poop, and with a nice 1 1/2 pound trigger that broke like glasss! They are good sh**s in my book.
    · Share on FacebookShare on Twitter
Sign In or Register to comment.