In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.

darne v19 shotgun

goatmangoatman Member Posts: 41 ✭✭
edited January 2008 in Ask the Experts
does anyone know how to take the sliding receiver off?i just purchased one with a broken extractor and need to tak the receiver off to get o it. thanks don
· Share on FacebookShare on Twitter

Comments

  • RobinRobin Member Posts: 1,228 ✭✭✭✭✭
    edited November -1
    Hello,
    I have a Halifax model and I suspect it is much the same. Move the slide to its most rear position. There is a little tang that hangs down on the rear underside of the slide, push that up. The slide should back off. Did you figure out how to remove the barrels? You have a neat interesting SxS good luck.
    · Share on FacebookShare on Twitter
  • goatmangoatman Member Posts: 41 ✭✭
    edited November -1
    yes this model has a button in the fore arm to remove the barrels. thanks for the info! don
    · Share on FacebookShare on Twitter
  • goatmangoatman Member Posts: 41 ✭✭
    edited November -1
    it doesnot seem to have the "tang" underneath. it was made in 1910.
    · Share on FacebookShare on Twitter
  • RobinRobin Member Posts: 1,228 ✭✭✭✭✭
    edited November -1
    My Halifax is early also but there could be differences. Will the locking handle on the slide "spring back" past the normal open position? If you can't figure it out contact Geoffy Gournet directly. You can find his contact number by Googling Darne and USA. Good luck, Robin
    · Share on FacebookShare on Twitter
Sign In or Register to comment.