Remington rolling block Parts????

treadlok97

Anybody Know where to get Remington Rolling block #4 Parts? I have not took it apart yet but the shell extractor will not pull the shells out. I have been told that there is a spring or a piece of spring steel that is bad to break. I have not found much for parts for these guns. Anybody have or know where to get parts for these?
Thanks

MIKE WISKEY

I have done some work on these, the spring you refer to 'ejects' the empty. The extractor pulls the empty from the chamber, if this isn't happening you have more serieous problems. Usualy a rough or enlarged chamber, or worn extractor.

treadlok97

Hey Mike, What to do if this is what is wrong???
Thanks

MIKE WISKEY

Well, if the chamber is bad you can reline the barrel, the ectractor can be replaced or rebuilt (neither are easy as parts are hard to find)

womacks4

www.rollingblockparts.com
We specialize in rolling block parts. We also list many RB parts right here on Gunbroker.
Your repair may only require the replacement of the three finger combination spring. On a rigid frame you will need to remove the breech block to examine the spring. On a takedown you can observe the front fingers of the spring with the barrel out of the receiver.
Kenn

bnailon

There's a fellow that restored my #4 Rolling Block--John Kubacka--a couple of years ago. Contact information is through Lee's Gun Parts in Irving, TX.[:)]

LEE'S GUN PARTS
3401 W. Pioneer Dr
STE 2
Irving TX 75061
972-790-0773