Noble sxs 12ga

jnjbrinton

Ihave a Noble sxs 12ga which was made in Spain. Having trouble disassembling. Can't remove the stock. I thing there is an internal screw in the receiver. The receiver has a floor plate with one screw. Can't remove it. Can anyone tell me how to disassemble this gun? Thanks JNJ

captkirk3@dslextreme.com

Have You pulled the Butt Stock to see if there was a Bolt Hole? Look and see if there is a Bolt...You might need a Flash Light to see whats at the bottom of the Well....

Ned Fall

What Captain Kirk meant to say is remove the butt plate from the butt stock. If there is a thru bolt holding the butt stock to the receiver you can then see the hole where it is installed. If there is a thru bolt (actually a screw) you'll need a six or eight inch screw driver to remove the screw.

jnjbrinton

Thanks guy's. No hole in the butt stock

GuvamintCheese

If you can post a photo Im sure we can tell you how it comes apart. There are problably only 5 or 6 screws total. One under the release lever and the ones under the gun. Remove the trigger guard and snap some photos, or just start taking out screws.

Ned Fall

Looked in Gun Parts catalog under Noble Guns and there are illustrations for Models 60, 60AF, 160, 65, 50, 80 and 70. Of course no mention of where they were all made but all show a through bolt (screw) holding he butt stock to the receiver. You didn't say what model you gun is.

jnjbrinton

Re Noble sxs some great pictures on http://mcb-homis.com/noble/ Any suggestions re disassembly appreciated.
JNJ