In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.

Bolt bending jigs

yblockheadyblockhead Member Posts: 947 ✭✭✭
in Ask the Experts
20230604_152513.jpg
20230604_152631.jpg

These were with a box-O-stuff that a friend of mine gave me over the weekend. He didn't know what they were for, but I'm a little above average and figure it out. Is there any market/value for these? (Note, If they are worth anything, I will post them on the site, and also the Arisaka bolt was not harmed in this photo op.......)

· Share on FacebookShare on Twitter

Comments

  • MIKE WISKEYMIKE WISKEY Member Posts: 10,043 ✭✭✭✭

    'back in the day' these were much used for turning mil-surps into nice sporters, not so much any more. sure, list them for sale but don't expect too much. it will help if you know which bolt they fit (other than the jap).

    · Share on FacebookShare on Twitter
  • toad67toad67 Member Posts: 13,008 ✭✭✭✭

    I don't think that there is nearly the amount of sporterizing done nowdays, seems like they still do quite a few 03's though. Wonder if an 03 bolt would fit in there?

    · Share on FacebookShare on Twitter
  • MobuckMobuck Member Posts: 14,128 ✭✭✭✭

    Neat relics but not much interest.

    I found the cut and weld method reduced the amount of heat on the bolt.

    · Share on FacebookShare on Twitter
Sign In or Register to comment.