In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.

Winchester M 94 butt plate

Idaho GIdaho G Member Posts: 138 ✭✭✭
edited May 2015 in Want Ads (NO 'FOR SALE' or 'FOR TRADE')
I have been looking for a Winchester M 94 steel butt plate like on the late 40' and 50's guns. Tried the usual sources, and Gun Broker parts with no luck. Anyone out there have one? Thanks.
· Share on FacebookShare on Twitter

Comments

  • CapnMidnightCapnMidnight Member Posts: 8,038 ✭✭
    edited November -1
    Buttplate w/ Screws, Rifle, Crescent, Steel
    5 & 6 883930B Buttplate w/ Screws, Rifle, Crescent, Steel $49.00 Buy Now
    This is for the crescent style, they also have the type your looking for.


    Numrich has them in stock. www.numrich.com
    W.D.
    · Share on FacebookShare on Twitter
  • Idaho GIdaho G Member Posts: 138 ✭✭✭
    edited November -1
    They have a plastic replacement. I'm looking for the flat metal buttplate, not the crescent one. It's for a M94 made in the 40's in 25/35. Perhaps someone has one that they took off a 94 to add a recoil pad.
    · Share on FacebookShare on Twitter
  • GunswapperGunswapper Member Posts: 1,058 ✭✭✭
    edited November -1
    What are the measurements? Length, width, and hole spacing. I think I have one or two. They are checkered steel.
    · Share on FacebookShare on Twitter
  • Idaho GIdaho G Member Posts: 138 ✭✭✭
    edited November -1
    The plate I need is fully checkered.
    Total length is about 4.665 inches.
    Hole spacing is about 2.85 inches center to center.
    Top hole is about 0.775 inches from the top.
    Bottom hole is about 1.05 from the bottom.
    There is a very slight curve to the plate.
    I also need the screws.
    Thanks
    · Share on FacebookShare on Twitter
  • pip5255pip5255 Member Posts: 1,625 ✭✭✭
    edited November -1
    I have one from an old 94 that measures 4.64 long 1.44 wide hole spacing is 2.88 c to c top down .775 bottom up 1.05 these were quick measurements with my mic but should be close to yours anyway.
    I also have the 2 screws that were used on gun, these are used original parts not new and the plate has some wear and slight bluing loss on high points and edges, if interested let me know thru email response and it has the slight curve.
    just because you could doesn't mean you should
    · Share on FacebookShare on Twitter
  • Idaho GIdaho G Member Posts: 138 ✭✭✭
    edited November -1
    Found a couple. Thanks for your help.
    · Share on FacebookShare on Twitter
Sign In or Register to comment.