H&R .32 S&W Mainspring

A-37

Need an H&R .32 S&W mainspring.

I'll try here before going to Numrich.

Thanks, Trap55. It's a flat spring.

TRAP55

Early and late versions, early used a flat spring, late uses a coil spring.

pip5255

I have some different ones can you provide length and width ?
model may help also.

Knifecollector

I also have an assortment of old H + R mainsprings, but would need some measurements to find an exact match.

A-37

I can't give any spring dimensions because the spring is missing. The notch in the hammer is 3/16" wide. The notch in the frame is 1/4".

Looks like the American DA See it here:

https://www.GunBroker.com/item/758127292

If someone wants to send me several springs, I'll buy the one I can use and send the rest back. You can contact me through the GB link above. Thanks.

pip5255

I have 1 of those revolvers, let me check it and I will see if I have the right spring for it.

my revolver is slightly different from yours so again I would need the length of spring, if you remove the grips you can measure the length with a rod from hammer slot to frame slot.

I also have reproduction springs that must be fitted to your pistol in different pressures that I used to reduce trigger pulls, $30 shipped

your picture is not an american model, looks more like the premiere and it should be the old model using a flat spring.

A-37

Changing direction. Getting rid of it as is.

Thanks for the inputs.

pip5255

well if whoever buys it wants a spring to fit it with let them know I have some available.

good luck.