In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.

custom brass

demo-dandemo-dan Member Posts: 109 ✭✭
Where can a person get a propietary cartridge made up?

Comments

  • Riomouse911Riomouse911 Member Posts: 3,493 ✭✭✭
    edited November -1
    Huntington Die Specialties sells tons of different brass, if they don't have something similar to what you want they'll probbaly know where to go...
  • 1fisher1fisher Member Posts: 1,012 ✭✭
    edited November -1
    For custom brass, I would call Rocky Mountain Cartridge in Cody, WY.

    They turn their cartridges on a lathe, so they can make anything - just give them the spec's.

    There is a bit of wait time - last time I bought from them, it probably took 4-6 weeks. But their stuff comes out beautiful.
    http://www.rockymountaincartridge.com/
  • nononsensenononsense Member Posts: 10,935 ✭✭✭✭
    edited November -1
    demodan,

    If you're asking about the high pressure variety as opposed to the low pressure or black powder cartridges then you need to talk to any of these folks:

    Conley Precision Cartridge

    Quality Cartridge

    Horneber (Germany)

    Starline Brass

    Hornady

    All of these companies will do a run of brass for you given two parameters:

    The design is not currently protected by law.

    Your order is sizable enough to make it worth their time.

    I just received 100,000 new cases from Hornady which was their minimum. The majority of the brass was pre-sold or we wouldn't have done it. Other companies might have different minimums but the prices will be higher, no doubt.

    Good Luck with your endeavor!

    Best.
Sign In or Register to comment.