In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.
7.62x39mm
rong
Member Posts: 8,459
Good morning.
I've started reloading for the SKS
and some of the cases look as if there
is a "ring" in the primer pocket.
A small rifle primer is way too small
and a large rifle primer is too large.
Not a big deal because I just have a dozen of these,
but has anyone run into this before?
Thanks
Ron
I've started reloading for the SKS
and some of the cases look as if there
is a "ring" in the primer pocket.
A small rifle primer is way too small
and a large rifle primer is too large.
Not a big deal because I just have a dozen of these,
but has anyone run into this before?
Thanks
Ron
Comments
Is the ring the primer crimp applied to military primer pockets?
There is a discernible ring in the primer pocket
that I think is stopping the new primer from
going in. Brass is PMC
thanks-ron
That ring is the crimp left when you punched the primer out. Take a champher tool and ream it out. Then the primer should go in.
I've encountered 7.62x39 Winchester commercial cases with a slight primer crimp. Some will reprime w/o reaming but several I've processed required a little cut to allow repriming.
chuck your champher tool up into a cordless drill. 2 seconds on low speed should be plenty. I've done thousands of military 223 this way. it works great.
+1
For large volumes, I clamp a drill in a vice, and that leaves both hands free for managing the brass.
chuck your champher tool up into a cordless drill. 2 seconds on low speed should be plenty. I've done thousands of military 223 this way. it works great.
-1. There are purpose made tools for this; Lyman primer pocket reamers, and swagers made by Dillon or RCBS. The problem with using a chamfer tool is, it is designed to cut at a taper, and leaves a beveled funnel like cut around the outside of the pocket. Which can- and does- lead to gas erosion of the bolt face. I left a ring on the face of my new Savage 12 in this fashion with loads that otherwise had no pressure signs, thanks to some crappy bulk processed milsurp brass that began its life with me as Ultramax remanufactured ammo.
quote:Originally posted by midnightrunpaintballer
chuck your champher tool up into a cordless drill. 2 seconds on low speed should be plenty. I've done thousands of military 223 this way. it works great.
-1. There are purpose made tools for this; Lyman primer pocket reamers, and swagers made by Dillon or RCBS. The problem with using a chamfer tool is, it is designed to cut at a taper, and leaves a beveled funnel like cut around the outside of the pocket. Which can- and does- lead to gas erosion of the bolt face. I left a ring on the face of my new Savage 12 in this fashion with loads that otherwise had no pressure signs, thanks to some crappy bulk processed milsurp brass that began its life with me as Ultramax remanufactured ammo.
+1
Use the lyman or RCBS primer pocket reamers, not your chamfer tool. Lyman now makes an "all-in-one" tool for brass prep for about $25 (how many pounds that converts to I don't know). Pretty useful And you store all the tools in the handle.