removing military crimp

dgac

What us the best way to remove the primer crimp? Forster makes a crimp remover for my case trimmer does any one have any experience with this tool? or is there another tool that is recommened?

dgac

How do you remove primer crimp in military brass?


dgac

perry shooter

either with a swageing tool put in a reloading press made by RCBS and others or with a reaming tool made by LYMAN, BONANSA or others look in either the Cabela's or MIDWAYUSA web site

brickmaster1248

i do it with a deburing tool. its slow but ive found no problems as of yet.

ww2buff9067

ditto on the deburring tool, but be careful to get all the crimp out

Mobuck

You product will be much more uniform using a swager tool but unless you're going to work several hundred cases it's too expensive.

B17-P51

http://forums.gunbroker.com/topic.asp?TOPIC_ID=295460

Eternal Sun 111666

Dillon Super Swage 600! Works great & Fast...a little pricy though, around $90.00

crowbeaner

I've used both the Dillon 600 and the RCBS tools. Since the effing burglars stole my 600 I've had to use the RCBS. It's slower, but does the job. I uniform the flash hole first and then swage to make sure the swage operation is as uniform from case to case as is possible. Sometimes a small ring of brass will be left in the pocket, so check each case after swaging. The primer pocket cleaning brush will remove the excess brass.