In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.

.223 and 5.56mm

Fade2GrayFade2Gray Member Posts: 54 ✭✭
edited January 2009 in Perry Shooter Competition Shooting and Reloading Forum
There has been a lot of talk around this forum about SHOOTING .223 and 5.56mm from the same guns. But, what I want to know about is RELOADING. Can my .223 and 5.56mm brass be mixed and reloaded at the same time with the same dies?

Thanks!
· Share on FacebookShare on Twitter

Comments

  • sandwarriorsandwarrior Member Posts: 5,453 ✭✭✭
    edited November -1
    Fade2Gray,

    Yes! The brass is the same dimensions throughout. One caveat to this though is more often than not mil-spec brass has crimped primers. You need to get a tool to either cut or swage that out. I use RCBS and swage it out.
    · Share on FacebookShare on Twitter
  • Fade2GrayFade2Gray Member Posts: 54 ✭✭
    edited November -1
    Thanks!
    I did know about the crimped primers. I have yet to buy a swager. I own a Dillon progressive loader, unfortunately I don't have the resources to set up and get to business. Hopefully my next PCS will lead to a more permanent location where I can get cranking.

    Is there a way to tell what is crimped or not? Should I just use a swager on it all?
    · Share on FacebookShare on Twitter
  • NwcidNwcid Member Posts: 10,674 ✭
    edited November -1
    Yes and no. Depends on what kind of accuracy you would like to have. Mil brass can commercial brass have DIFFERENT internal sizes due to the Mil brass being thicker. This means you will end up with different pressures with the same amount of powder in the different kinds of cases. If you are just blasting ammo I would say no biggie but if you want accuracy, no way.

    As it was said Mil brass has crimped primers so you will need to deal with those. It is not a big deal to do, just one more step. Depending on how many you have to do will depend on the decripming too you need costing from $10-$100.
    · Share on FacebookShare on Twitter
  • B17-P51B17-P51 Member Posts: 2,248 ✭✭✭
    edited November -1
    Big +1 on Nwcid. Drop whatever your favorite load is with commercial brass at least .5 grain and sometimes 1.0 gr with a powder that is a little faster.
    · Share on FacebookShare on Twitter
Sign In or Register to comment.