In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.
Neen a load for 45 long Colt, Hornady 200gr SWC
3dshooter
Member Posts: 4 ✭✭
Hey there, everybody. I picked up the wrong box of bullets (I thouht they were jacketed ball). What I have is a box of 200 Hornady 45 cal. (.452) lead 200-grain semi-wadcutters. I have some Winchester 231 ball powder I would like to use with these bullets.
I have never loaded plain lead bullets before. Do I need a gas check for this bullet, or is the speed slow enough to not matter?
The revolver I'll be loading for is a J.P. Sauer & Sohn SAA Western Six-Shooter Model, chambered for 45 long Colt, imported in the 1950s or 1960s. It a lot like a big Ruger SAA, and it shoots great.
The only other handgun round that I reload is the .45acp. Most of my reloading is for rifles: .223 Remington, .30-30, .270, .30-06, and 8mm Mauser.
I have never loaded plain lead bullets before. Do I need a gas check for this bullet, or is the speed slow enough to not matter?
The revolver I'll be loading for is a J.P. Sauer & Sohn SAA Western Six-Shooter Model, chambered for 45 long Colt, imported in the 1950s or 1960s. It a lot like a big Ruger SAA, and it shoots great.
The only other handgun round that I reload is the .45acp. Most of my reloading is for rifles: .223 Remington, .30-30, .270, .30-06, and 8mm Mauser.
Comments
For a lead semi-wadcutter (200 grain, .452" diameter) and 231 powder, they list the following loads and muzzle velocities:
Starting load: 7.3 grains 854fps
Maximum load: 8.3 grains 998fps
Standard warning: Bold print denotes maximum loads. They should be used with caution.
Cartridge overall length (COL) for these loads is listed at 1.515" and CCI 300 primers were used in these loads.
Taken from 45 Colt section of the Speer book:
"The 200 and 250 grain lead semi-wadcutters make nice practice and target loads. The 200 grain bullet should be firmly roll-crimped over the shoulder. The 250 grain bullet will shoot very close to point-of-aim in fixed-sighted revolvers; however, the 200 grain bullet may shoot somewhat low."
Hope this helps!
As always, you should check this info against other sources that you have available, and err on the side of caution when working up your loads.
Big Al (I've really got to get started with my own, doggone it!)
Big Al (got so many projects and so little time...how'd that happen, anyway? ) [:D][8D]
45-200 lead SWC which should be similar to yours.
He did a 1000 rd test of the then available powders and found Herco to work best for accuracy and cleanliness.
This dates from a few years back before the new powders.