In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.
Archery Deer Hunt Season is upon us...
retroxler58
Member Posts: 32,693 ✭✭✭
And I found myself without a necessary tool to install my broadheads...
So a few minutes later scrounging through the recycling bin...
I found the perfect place to start...
A Hard plastic jar lid... Mine is from a Mr.Peanut Jar.
I simply drilled a 3/16" dia hole in the center.
And cut slots with the Dremel at 120 deg from each other.
I used a 30-60-90 triangle... But you can get pretty close by eye-balling it.
Marked the places for the slots with a Sharpie.
Then cut the slots with the Dremel disc cutter...
It works pretty good. Saved a couple of bucks and a 40 mile round trip to town. [:D]
I just LOVE IT when I can save a buck... [^]
So a few minutes later scrounging through the recycling bin...
I found the perfect place to start...
A Hard plastic jar lid... Mine is from a Mr.Peanut Jar.
I simply drilled a 3/16" dia hole in the center.
And cut slots with the Dremel at 120 deg from each other.
I used a 30-60-90 triangle... But you can get pretty close by eye-balling it.
Marked the places for the slots with a Sharpie.
Then cut the slots with the Dremel disc cutter...
It works pretty good. Saved a couple of bucks and a 40 mile round trip to town. [:D]
I just LOVE IT when I can save a buck... [^]
Comments
I've never had the need for one though. I've always used mechanicals.
Found this on Friday evening as I was inspecting my gear for Saturday...
Contacted Parker and they're sending two replacements... One to install... One jus'incase.
Maybe this Saturday I'll get in the woods finally... [:p]