In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.

Led nock installation

JimmyJackJimmyJack Member Posts: 5,506 ✭✭✭✭
edited January 2014 in Bow Hunting and Target Archery
How do you work wirh carbon shafts? Heat them just a tad?
· Share on FacebookShare on Twitter

Comments

  • dcso3009dcso3009 Member Posts: 2,350 ✭✭✭✭✭
    edited November -1
    Should just slip in. Fit should be snug, but most nocks do not take well to heat. I have seen them become brittle & shatter after just a little heat.

    Check to make sure you have the correct size for your shaft.
    · Share on FacebookShare on Twitter
  • JimmyJackJimmyJack Member Posts: 5,506 ✭✭✭✭
    edited November -1
    Putting them in is one thing, the old ones dont just slip out. Ive been working with arrows for forty years so its not new to me, but I dont want to heat the carbon arrows if you are not supposed to.
    · Share on FacebookShare on Twitter
  • Chief ShawayChief Shaway Member, Moderator Posts: 6,280 ******
    edited November -1
    Are your old nocks glued in?
    If so, you are screwed for LED nocks.
    To the best of my knowledge, no good will come from heating a carbon arrow shaft.
    The nocks on my carbon arrows turn freely and with a little force pull out.
    On the Lumnocks, they work by moving forward and making the switch.
    · Share on FacebookShare on Twitter
Sign In or Register to comment.