In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.

Lyman Plainsman Leaky Frizzen

n/an/a Member Posts: 168,427
My priming powder keeps disappearing while hunting. Any suggestions?

Sage 1

Comments

  • hillbillehillbille Member Posts: 14,086 ✭✭✭✭
    edited November -1
    hold it horizontal while carrying, it is a pain but it will keep it in..........
  • navc130navc130 Member Posts: 1,186 ✭✭✭
    edited November -1
    1. Try for a better fit between the pan and frizzen (may not be possible).
    2. Wax or grease to fill the gaps, which also waterproofs.
    3. Epoxy along the edge of the pan which should last for a season.
    4. Solder along the edge of the pan which should be a permanent fix.
  • andrewsw16andrewsw16 Member Posts: 10,728 ✭✭✭
    edited November -1
    A thin layer of JB Weld along the mating edges, let cure, and then file down until there is a perfect fit. Color the gray to a black color with a Sharpie and you are done. Don't go overboard when putting on the JB. The probability is that you have a tiny mismatch in the mating surfaces. So, just put on a THIN layer and then use a fine flat file and some emery paper to shape it down to the perfect surface. Have fun. [:D]
    The alternative is to just wait until you see a possible shot, and then prime the pan.
Sign In or Register to comment.