In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.
Scary safety problem.
Hwallbanger
Member Posts: 48 ✭✭
I bought a Churchill 30-06 with a Timney trigger ,if you happen to pull the trigger just a little and then release the safety the fireing pin falls, scary . What is wrong ,Thanks.
This discussion has been closed.
Comments
your trigger needs adjustment..........check with timney for instructions
Nice example of why you NEVER depend on a safety.
Is the safety part of the trigger or a bolt cocking piece type?
Your trigger has either been misadjusted, modified or wrong from the factory to begin with, and I would contact Timney for guidance. There is also the slight possibility that there is a problem with the bolt, but I would go with Timney first.
Need to know this first.
I can't answer that ,I did disasemble the bolt and the cocking piece end had been ground off the bottom end ,I guess to make the trigger fit and didn't know what they were doing. Bought the gun on an on-line auction .Beautiful gun ,I'll take it to a good gunsmith and see what he can do with it. Thanks for the replies .
AGAIN, is the safety part of an aftermarket trigger (Timney or Bold or ??) or is this a safety that engages the cocking piece/striker?????????????????????????
A gunsmith should make it right, maybe by replacing what is malfunctioning. I have a Marlin Model 15 with a similar problem. If you have it on safe and pull the trigger really hard, when you release the safety the gun will fire. I also have a Colt Huntsman which will fire with the safety on if you pull the trigger with 20-25 lbs. of force. As you pull the trigger the safety will raise slowly to the 'off' position. Don't trust safeties.
check the overt