In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.
Trouble with acuracy with my 22-250AI
snowy1
Member Posts: 67 ✭✭
Help.........the original factory loads were all shoooting in a 2 inch group when I fire formed the cases but after reloading it is hard to get on the target at 50 yards. Only 6 hits out of 20 and it was in a horizontal string measuring 3x8 inches. I admit I am new at reloading but can the wrong load cause that much difference or should I suspect something else such as the scope? Very frustrating and will appreciate any advise.........Snowy
Comments
Did the cases form completely the first firing??
What was the load??
How much neck tension??
stock torqued correctly??
if you truley are getting a 3x8 with a proven scope,..you have a serious issue somewhere. Sounds like a bad scope or loose rings or a horrible stock issue.
Did the cases form completely the first firing??
What was the load??
How much neck tension??
stock torqued correctly??
JustC has some very good advice here! To me it sounds like something is loose! Another thing to remember is some rifles, especially in 22-250 are very particular to what powder they like. Keep that in the back of your mind, OK. I personally don't reload for the 22-250, but have several friends that do, I'll try to see what powders their rifles liked, that might give you a place to start. Good Luck and Good Shooting!
If you see a puff of "smoke" about 20-30 feet in front of the rifle when firing, that is your issue. You need something a little more solid for a pill for this one.
quote:Originally posted by HandgunHTR52
What bullets are you using? I am inclined to believe what perry shooter stated about the bullets coming apart.
If you see a puff of "smoke" about 20-30 feet in front of the rifle when firing, that is your issue. You need something a little more solid for a pill for this one.
Problem solved!!!!!!!!!!!!!!!! I went back to factory loads and the problem disappeared so the scope was fine. I reduced the powder charge 5 grains and the the problem went away. Still not as tight a patern as with factory loads but a little tinkering with the load should tighten it up. Thanks to everyone for their expert advice.....Snowy
quote:Originally posted by HandgunHTR52
What bullets are you using? I am inclined to believe what perry shooter stated about the bullets coming apart.
If you see a puff of "smoke" about 20-30 feet in front of the rifle when firing, that is your issue. You need something a little more solid for a pill for this one.
You mentioned you where shooting a 22-250AI is'nt the akley improved, twisted for heavier bullets ? I know that if you put a light bullet in a fast twist barrel with a high or near max charge you will get similar problems
#2-- Where in the world were you at 5 grains more ????
quote:Originally posted by JustC
yes,..I was wondering about the 5 grain decrease myself. What was the load??
Looks like you learned a good lesson here. When a problem devlops always go back to square one and repeat. If you regain your performance you must suspect your abilities not the guns. You then try to figure out what you did wrong and correct it.
A hot tip passed on to me by a professional engine tuner: make one change at a time, test for success, and adjust as needed before making any other changes. This way your baseline performance can be a guide to any adjustments made in the load, gun or style of shooting but only one change at a time!
The reloading manuals always suggest you reduce maximum loads by at least 10%. I think you should take that advice to heart! remember you can always make the next batch hotter![8D]