In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.

2" 410

TaiChiTaiChi Member Posts: 179 ✭✭✭
edited October 2009 in Perry Shooter Competition Shooting and Reloading Forum
Looking for a source of 2" 410 shells or info on cutting down 3" hulls to reload. These would be for a Marbles Gamegetter.

Thanks,

Steve

PS Best gun site on the web !!
· Share on FacebookShare on Twitter

Comments

  • Rocky RaabRocky Raab Member Posts: 14,438 ✭✭✭✭
    edited November -1
    I used to make cylinder-length .410 shells for my 45 Colt. They ended up being about 1 3/4" and held about a half-ounce of shot.

    I simply sized the hulls in a Lee Reloader (the * that uses a mallet), then trimmed them flush with the cylinder. About five grains of Unique is plenty. Then I trimmed 410 shot cups so they'd be just a bit shorter than the hull when seated over that charge. For an over-shot wad, I cut tablet backer with a 40 S&W case. A ring of hot glue holds it all together. Done.
    I may be a bit crazy - but I didn't drive myself.
    · Share on FacebookShare on Twitter
Sign In or Register to comment.