In order to participate in the GunBroker Member forums, you must be logged in with your GunBroker.com account. Click the sign-in button at the top right of the forums page to get connected.
Options
Taurus Judge
59BURST
Member Posts: 14 ✭✭
Looking for opinions on who has shot these in either 3" or 6" barrel. Thanks ..
Comments
Does it shoot OK after you clean it? A friend has the same problem with shot shells. We figure it is unburnt powder locking the gun up.
I have not tried it again. It marked the rear frame pretty good. I called Taurus & they told me to send it to them for inspection. Thanks for your reply. Dave
i went to the range fired i shot(410,tight fit)cylinder jammed and wont rotate,cant open it still has 4 loaded in it.any suggestions ?
i will post for help but wanted to respond to 59burst.
edit I came to same conclusion about the chamber step. I have been shooting up a lot of old ammo collected here and there.
I got one of the first ones with long cylinder. Works fine so far but hard ejecting 3" .410 empties. Have to bump them free on the heel of my boot.
There is a internal flange in the chambers, to prevent dummies from chambering .454 Casual & .460 S & W. This causes problems with the extraction and ejection of shotgun shells. When I had my Judge the shells that caused me the least problems, were Winchester A A's with the thick plastic walls.
Only problem so far is I need to pull empty .410 cases out by hand.
this judge will fire everything else,but when i put a winchester shell in it jams ist time.
i bought an u/l shoots everything no problem.
gl
pat